µMETOS - Configure APN

Before You Start

To configure the APN on the µMETOS, you will need:

• Computer
• USB cable Micro
• Your station is running with the latest firmware (recommendation)
• The battery is charged to approximately 6.5V
• Physical access to the station

Step 1. Download and install the latest release of the PI Service Terminal by clicking on THIS LINK.

➡️ In case you do not know how to install it, you may find THIS GUIDE useful.

Step 2. Launch PI Service Terminal.

Step 3. Unplug the battery and the solar panel.

Step 4. Plug in the USB cable.

Step 5. Plug in the battery.

Step 6. On PI Service Terminal, make sure a COM port has appeared and click to "Connect".

Step 7. (If the menu is not shown), press "H" to show it and press (P) for MODEM PARAMETERS:

    ➡️ This process requires a few seconds while the station checks the sensors and confirms the modem's functionality, after which it initiates the GPS scan. To abort the GPS scan, just press the 'ESC' key. If nothing shows up on the screen, hit 'H'. If nothing occurs, check the USB cable and switch the station OFF and ON.

P - Setup modem parameters

Step 8. Configure the APN with the options '3 - APN NAME', '4 - APN LOGIN' and '5 - APN PASSWORD':

3 - APN NAME                      -> None
4 - APN LOGIN                     -> None
5 - APN PASSWORD                  -> None

1NCE:
APN address: iot.1nce.net
User: no need
Password: no need

Vodafone:
APN address: lpwa.vodafone.iot
User: no need
Password: no need

CONGRATULATIONS! The APN has successfully been updated.

Need Help?

• EXTRA INFORMATION IF REQUIRED - LINK
• If you encounter issues during this process or have questions about the information described in this page, please SUBMIT A TICKET to the METOS Support Center and include all the required information.

SUBMIT A TICKET